Showing 1–16 of 233 results
BANSEN-0020
Egg counter Banner sensor (yellow) normally used for egg counting.
BANSEN-0030
Egg counter Banner black egg counter, SE612CV
C2 Assemblies-0010
Air inlet board Air inlet board, complete, includes Solid State Relays and IC’s
C2 Assemblies-0020
Vent board Vent board complete, includes Solid State Relays and override thermostat relay
C2 Assemblies-0030
Feed/Light board complete Feeder / Light board. Four high voltage (120-240 VAC) outputs. Use solid state relays control by 5 VDC. Computer / Time Clock switching for each output.
C3-0001
C3 Fuse Kit C3 Fuse Kit
C3-0004
4-slot Command III Rack Assembly Command III 4-slot Rack Assembly. Houses the CPU module and up to 4 modules in various combinations of Digital Input, Digital Output, and Analog Input modules.
C3-0008
8-slot Command III Rack Assembly Command III 8-slot Rack Assembly. Houses the CPU module and up to 8 modules in various combinations of Digital Input, Digital Output, and Analog Input modules.
C3-0012
12-slot Command III Rack Assembly Command III 12-slot Rack Assembly. Houses the CPU module and up to 12 modules in various combinations of Digital Input, Digital Output, and Analog Input modules.
C3-0020
Command III Digital Input Module Assembly The Digital Input Module Assembly can accept 32 digital inputs per module. The digital inputs are used for counting eggs, water pulses, rpm pulses, on / off status of various devices. Connects to a digital input termination board.
C3-0030
Command III Digital Output Module Assembly The Digital Output Module Assembly can control up to 32 output devices per card. Used to run fan, feeders, lights, baffles, etc. Connects up to 4 Relay Termination assemblies per module (8 outputs per assembly.)
C3-0035
Command III Relay Term Bd Assembly The Relay Term Board Assembly provides 8 double pole, double throw outputs.
C3-0040
Command III Analog Module Assembly The Analog Module Assembly connects to an Analog input / output termination board. It can monitor up to 24 analog inputs (temperature probes, lights sensors, static pressure,etc.) It has the added bonus of being able to control 4 analog outputs, normally 0-10 vdc.
C3-0050
Command III Remote Serial Module Assembly Remote Serial Module is used to interface up to four(4) RS-232 serial signals from a scale display(s) to the CPU module. It is also used for receiving counts from mux boards through the RS-485 port.
C3-0060
Command III CPU Module Assembly The CPU Module Assembly controls the input and output modules in the rack. It also provides two serial ports that can connect two remote serial module assemblies. It also provides a network jack for connection to the local area network of computers, other C3 racks and displays in a complete […]
CHIPSET-0010
Uniface chip set Uniface chip set